Home / Light Fixtures / installing exterior light fixture on vinyl siding / Vinyl Siding Mounting Block Lowes Vinyl Universal Mounting Block How To Install Outside Light On Garage Certainteed Mounting Blocks
Katy Light Fixtures May 15th, 2018 - 08:35:52
Build the new assembly by carefully following the manual that contains the manufacturer`s directions. While doing this it advisable to leave all bulbs or lamps out of the unit until it is installed properly. Locate the ceiling studs where the base of the new unit will be attached.
As you can see there are many types of lighting fixtures and how to use them. You have a lot of choices and you should make those choices wisely. You will soon discover that you want good lighting that works where you need it. You also want it to look nice and not cost very much to use.
In case there has never been a previously installed lighting fixture and the breaker for the fixture has not been indicated on the new breaker box one needs to determine the circuit that will power the lighting. In order to do this one needs to have somebody else turn the power switches off and on while testing the exposed wiring where the new fixture will be fitted each wire at a time using a voltage tester. Once the circuit that will power the new fixture is determined the beaker should be marked and then turned off.
At this point it is advisable to tape the beaker over just in case someone might turn it on while one is in the process of installing the new lighting fixture. Use the voltage tester to recheck the wires again even after turning the beaker off in order to be guaranteed of safety since working with live wires is a bit deadly.